Member postings for Harry Wilkes

Welcome to the forum

H

I purchased at kit at the Midland Exb around 2018 and installed it without any problem on my Myford S7.

H

Strange one i run Firefox and have AddBlock plus enabled and it's still going at it like there's no tomorrow

H

Welcome to the forum

H

some years back I need to cut a thread on site I had the 2" die but no die holder I managed using a jubilee clip with a screwdriver in the gap, yes bit 'sketchy' but done the job

H

Tek it ta bit's as my mate would say (hope Ive got the black country spelling)

I have a redundant sky + box so pulled it apart not a lot in there but there was a nice 500 Gb Seagate hard drive useful if only for the magnet

H

I mill on my Myford as I dont have room for a milling machine I have used used the sliver of paper as suggested by Chris also I have some Myford collets but again as suggested invested in a set of ER25

H

My notification came today better than a kick up the backside

H

Welcome to the forum

H

Welcome to the forum

H

Welcome to the forum

H

Without going into the pro's n con's you find on youtube on creator fits a 6 jaw chuck then other do bit like when someone put a steering wheel on their mill everyone got on the band wagon

H

Welcome to the forum I use a rear tool post for parting off next used it for anything else but I struggled at times parting off since using my rear tool post not had a problem

H

I believe first test x2 working press and thereafter x1.5

H

Fellow club member ran his two Folwer ploughing engines on gas he had no problem with his engines or gas bottle getting tested or insured. The only drawback was running the engines on the rally field they struggled however when he ran them static they performed OK The small sized cylinder was stored in the riding trolley.

Thanks for the heads up Neil let's hope all goes well

H

Dell link to another video on subject link

https://www.youtube.com/watch?v=qySEfau12Z4

H