Take 1 1/2 hors of your life to watch this

This will shorten your life by 1 1/2 hrs but well worth watching. Give the Wife 20 quid to go shopping & watch this. I am lucky I don't have a wife. Sorry messed up the title .

**LINK**

Edited By Steviegtr on 19/01/2020 03:25:04

I think this will be my 1st project. NOT.

**LINK**

Heaps of good technical information and pointers for machining and worth watching but like many Youtube videos too much un necessary waffle. Video could have been reduced to 1 hour or less.

Paul

If you think £20 will take the wife shopping for 90 minutes im not suprised you havnt got a wife (only joking)....give her £150 and you might be in with a chance.

For those that don't know Debolt where the video was taken are a well known supplier of hit and miss engine kits in the US as well as making complete engines and a line of machined smaller parts for them. I have made a couple of their engines.

Think I'll keep the £150 and put that towards another engine

Edited By JasonB on 19/01/2020 10:24:47

Thanks for the link JB...never heard of them, but they make some nice, if expensive complete engines. Going to take a few cancelled shopping trips to get this...**LINK**

very nice but don't know which tape-measure they were using -
12 1/16" flywheels, total height 11 1/2" 4/10 scale
DaveD

They used the right tape on the flywheel, I was asked to make one of those for someone but flywheel was a bit too big for may lathe. about 21 1/2" tall so a typo.

They only do limited runs of their engines which is why there are not many listed and they are quite sort after.

Edited By JasonB on 19/01/2020 16:01:14