using the Worden

can anyone help me with a copy of the instructions which came with the 4 facet drill sharpening jig from Hemingway, please.

After house and workshop moves some of my paperwork has gone 'missing'.

If anyone can help I would be very grateful.

Regards

Edited By Deric on 06/08/2018 21:12:22

Stating the obvious, perhaps, but a set of destructions from Hemmingway represents only about 3%, or so , of the total cost of the kit.

Clearer now that is not actually a ‘sheep deepening jig’. Predictive text or auto correct fails so often...

Deric

Have sent you a PM

.

HK 1310 [the 4-facet jig in question] appears to be priced at £32.10 **LINK**

http://www.hemingwaykits.com/acatalog/Worden_Mk3_Tool___Cutter_Grinder.html

MichaelG.

What did Hemingway say when you asked them how much a new copy of the instructions would be?

I don’t see ‘Worden‘ mentioned anywhere but on the one kit. If OP is not clear, then he gets an unclear response.

Like computers - carp in, carp out.

Whereabouts are you?

Perhaps someone nearby would lend you their Instructions.

(if you choose to copy them for your personal use/study, you may not run foul of the copyright law)

Howard

Thank you all for your comments.

I spoke ti Kirk at Hemingway and he very kindly helped me with a copy of the instructions.

Excellent service and I am very grateful, I have previously built the Worden and accessories, bending rolls and the graduating tools all of which have proved enjoyable to make and proved to be useful tools.

Thanks again

Deric