Member postings for Mike p

Hi Eric, I have noted your comments on the different dimentions given for Fig. No.24 being confusing and would also like to point out on Fig. No. 29 the lengths of the valve push rods are also confusing as linkage 1 & 2 areshown to be 29mm but Link 3 although drawn as noticably shorter is given no dimention. Do we make several at differing sizes or is an update forthcoming.

Mike p

Hi, I have just looked in Blackgates Engineering catalogue and find the 3/8" od listed at 36p. I have used them before and found them most helpful. My catalogue is for 2009 I doubt they have increased by much. Their phone No. is 01924 466000  or www.blackgates.co.uk

Mike p

Edited By Mike p on 02/07/2012 16:30:35

Hi David, Yes I can access everything as I am a subscriber to both magazines so I assume my entry to all parts comes from either subscription. It is not a problem for me at the moment problems will probably arise when my actual renewal dates come round, maybe all will be sorted by then.

Best Regards

Mike

Hi David, My MEW subscription date is OK but my ME date is skown as 01/01/1900 which is obviously incorrect if that helps.

Regards Mike p

Hi David, The subscription gifts seem like a great incentive to subscribe but quickly loose their charm when they don't arrive. I subscribed in February 2012 and never received anything. When I telephoned My Hobbystore to find out why I was told that although the database shows that I am owed these gifts they are not now available. I then suggested that this being the case i was quite prepared to accept the current gifts as an alternative, I was told that this was acceptable and I would receive these as a substitute. That I thought was an end to the problem but as yet I have still to receive anything. Perhaps you might consider looking into this for me.

Regards

Mike p