Member postings for Andrew Ellis 3

Hi @Bazyle

I took the photo.

I was drilling out the centre of a Slater's wheel so I could fit it to a Dapol axle. MY Dad runs 16mm narrow gauge live steam, and I run 7mm standard gauge on the same track. I need to use coarse scale wheels as the fine scale wheels won't run through the points.

Hello, the link to the Facebook group is:

**LINK**

And the link to the website I'm working on is:

**LINK**

There is not much to see at either yet, but I hope to add to both over the coming days.

Hi everyone

Thank you for your replies and suggestions.

I have registered a domain, and started work on a website for my group. I also have created a facebook group. Am I allowed to post links to them here?

Hi Howard,

Thank you for your reply, and suggestions.

This is what happens when one doesn't get on with things straight way, time slipps by very quickly. These last few weeks have been very busy.

I have created a group on facebook, I'm not sure if I'm allowed to share the link here; I'll need to check that.

I have mentioed this to a local network called spotted in Ely, so I'll see what interest there is.

Andrew

Hello,

I have come across this post some 5 years after it was created!

I am interested in founding a model engineering group in Ely, and was wondering if there is any interest?

I was thinking of beginning with some kind of online forum allowing for Q & A and show & tell.

I'm not sure the best way to go about this, I was thinking of starting a group on Facebook. But if anyone has a better idea I'm happy to go along with that.

Andrew