Member postings for Robert Askew

moving clock across using handwheel

Warco claim on there report .04mm or .0015 in proper measurements

Tried adjusting jibs and locking head locks no different

The machine is on it’s supplied stand and I paid extra to have warco to fully install machine in my workshop

Have found problem not that it helps bed is not ground parallel to the dovetails underneath

I run the clock across width of table and clock went from +.004” to -.004”

So will demand a new machine

Lower at back higher at front

.004” low at back .004 high at front

sorry but not exctable to me

.008” over full with of table 8.5 “

super major vario

just had my Warco Super Major Verio delivered 15/02/2019

and checking spindle squareness to table

left to right x Axis spot on front to back y axis.008 out not happy

waiting for an answer from warco

i am not making a sterling engine,I am making a Bengs hit and miss open crank 4 stroke engine,the problem is some the drawings are missing dimensions, I have to keep e maling bengs to get the sizes,and they don’t seem concerned that they are missing

just got my kit

and I must say the drawings and info supplied leave a bit to be desired

The machine I was looking have just found out is 415volts so now looking at Warco WM 20

Anybody got one or know anything about them

Sorry I am asking this but this but I am using a bridgport vmc 1000 daily for my job and anything else seems small and weak

looking for a new milling machine not sure what to get

Then I came across a make called Bernardo looks like they are German or Austrian

Anyone know anything about them

Rob

Hi all new here but not new to machining been my job for 40 years

Rob