Member postings for Conrad Thompson

Hi, Jason, thanks for a speedy response. The reply email was devoid of any details, so must have been wiped as you say. Thanks for the help.

Conrad

Hi, I am new at this so please be patient with me. I have received an alert email from someone responding to one of my ads. Fortunately the sender included a phone number and I spoke to them , so all appears well so far and its not a scam. However there is no message in my inbox on the website from this sender and I am not sure if he received a message when I chose the reply option on my private email. The email header is from [email protected] .

Have I missed something in setup or profile?. I sent myself a test message and it appears in the inbox. It is the only one. what am I doing wrong. Thanks.

Conrad

Hi folks,

I need some help.

The speed control on my Sieg X1 mill is misbehaving. If I switch to the forward or reverse position with the potentiometer switch in the Off position, the motor idles at a low rpm, with little torque. When the pot is switched on the speed control works as normal with good torque. The power light is not working and I know this is sold as a spare so it may be faulty. Anyone experienced this type of problem? Is it the board or the pot or both? or forward / reverse switch (which is also sold as a spare)

Any thoughts and help greatly appreciated.

Thanks

Conrad