Member postings for Jimillsortit

Hi Les

I have to say thanks for posting the above schematic and picture, I had been pondering how to get a remote control starter for a Teco T-Verter to lock in for a few days, pardon the pun but the penny dropped when I saw your picture and schematic. I ordered a couple of SCR's from ebay and got the the unit to work first time but was a little careless when tiding up the wiring and broke one of the pins (they are really delicate) on the SCR so had to do it all again, you can see from the photo below it has turned out quite well. I will post more photos on my thread for my mini mill I started a while back as I don't want to hijack this thread.

Jim

Edited By Jimillsortit on 29/03/2014 19:44:51

Edited By Jimillsortit on 29/03/2014 19:45:27

Edited By Jimillsortit on 29/03/2014 19:46:06

Thanks Nick

This just confirms what others have advised above especially the picture of the motor plate.

Regards

Jim

Thanks for the offer Kevin but I now understand how the motor is fitted so don't give yourself extra work.

Jim

Thanks Kevin the pictures are helpful they let me see the proper setup.

Peter that's kind of you I will PM my email address thanks.

Thanks for prompt reply guys.

John when I measured the Morse Taper I thought it was MT 2 so I will have to recheck that.

Hi

Been browsing the forums for a few months now and finding my way around, some very interesting models and machine information which is where I need some help.

I purchased the mill drill less a motor which someone has tried to alter , I would be grateful if someone could advise from the picture what model the mill is, if anyone has a parts list or could advise on the motor kW and frame size required that would be great. I realise you might require some measurements which I can post up.

Ignore the pully sitting on top it was just a handy place to sit it.

Thanks in advance

Jim