Member postings for Shed Full Fred

Hi,

I purchased a pair via Ebay. Does anyone recognize the pattern?

Probably 7 1/4" gauge.

Raw Dimensions

Bore 1 1/2"

Length 4 1/4"

Height 3 5/16"

Width 3 3/8"

Afternoon,

Does anyone know where I might find a set of drawings for a 7 1/4" gauge LMS 4F? I have four here:

General Arrangement

Cylinders

Cylinder Details

Tender GA

Looking for the remainder...

Regards,

JP

Well, thanks for replies so far. There must have been a UK interest in 4 3/4" as articles by ND Willoughby (and his father? brother?) were published in ME several times.

Evening,

Does anyone know of or have any details of this locomotive designed for 4 3/4" gauge? A while back I bought from Ebay three drawings for this locomotive. These are side elevation, sectioned side elevation and main frames/buffers/stretchers.

A search via an online ME index provides comment upon ND Willoughby, GS Willoughby, and as mentioned elsewhere in this forum their 0-6-0T "Pioneer".

But, alas nothing on the 4-4-0...

Regards, JP

Evening All,

Can anyone suggest a possible source from where I might obtain a copy of a General Arrangement drawing for a GWR 2-4-0 Metro? As in for the full size 12" to 1'0" scale. Not Martin Evan's 5" gauge version, I already have the set to hand. I'm normally looking around for Narrow Gauge drawings and am familiar with where to look for those.

I look forward to hearing hopefully from someone,

Regards,

Jonathan

Hi Everyone,

Does anyone know where I might find a General Arrangement drawing for the Lough Swilly 4-8-4 tank locomotives? I have in the past (before they moved to Statfold) tried the Leeds Industrial Museum but to no good end...

Regards,

Jonathan

Hi,

Has anyone considered using acetylene at low pressure generated from a system similar to old bicycle lamps?

Regards,

SFF

Hi

Does anyone have a drawing for either of the Jowitt steam engines manufactured by Chelston ME? The Stan Bray build was interesting back in the 1980's but no drawings...

Best Regards

Jonathan

Hi,

Does anyone have a drawing for the Stuart Turner Sandhurst engine?Have tried contact with Stuart Turner themselves to no avail...

Best Regards,

Jonathan