Member postings for Andy Seal

Thanks to all who provided help with my problem I'm going through all of your suggestions .couldn't believe how much response I got, amazing

Thank you all for your replies they are most helpfulsomeone asked how I was holding the work well I've tried it all ways , clamped in milling machine, clamped in movable vice on pillar drill so as to enable the drill to find the punch hole

Hi guys

Despite ensuring everything is level I cannot seem to drill a hole so that it is exactly in the right place on the reverse side. Ive got 56 holes to drill in 6x6mm square brass stock ,no room for error as each hole has to be tapped for M3 bolts.I m using 2.5mm cobalt drill ,brand new,.

I'm obviously doing something wrong can anyone point me in the right direction

Thank you

Andy

Thank you for that Jason that's great news,how s the best way to contact him ? Sorry I 've only just joined this group so not familiar with the protocol yet but thanks again for your help.

Andy

Hi everyone

I'm new to this apart from making very basic steam engines I've not yet ventured into my ultimate build so I thought I would start with the decauville 020t 45mms as Utube show a pretty good 34 episode step by step on how to build it however I still would like the plans for it.Can anyone help as I have had no luck searching the net .it also would be good if they were in English but not essential.

Thanks guys

Andy