Member postings for mother

So no brass for the safety valve ..

Paul

hi guys

many thanks

will stick to the expensive stuff then p/bronze and gunmetal

cheers

paul

Hi guys

I have just started to build a sweet pea also ..... made all the easy turned parts the pins and studs etc

Just started the brass work

Catch you later

Paul

Hi guys

I have just started to build a sweet pea also ..... made all the easy turned parts the pins and studs etc

Just started the brass work

Catch you later

Paul

Hi guys

I'm in the processof building a sweet pea and I was wondering with the bronze and gunmetal ...would brass be an alternative. And maybe Ali Nickel bronze ( I can get plenty of off cuts from work ) please forgive my ignorance this I s all new to me

Kind regards

Paul

hi guys

thank you very much for your replies....

im hooked already....looking at joining a club as we speak...

I have a workshop with a lathe and a Bridgeport clone turret mill..catch you here soon

regards

paul

hi guys

I would like to build my own steam engine... just like you chaps....

could anyone recommend a good engine and where I could purchase the drawings please..

im an aerospace engineer so not too concerned about the complexity but would like to make a good size engine one that could pull me and the boys...

any start up advice would be greatly appreciated ...should I join a local club ...

im in the Bradford area

many thanks guys

cheers

paul